Host Pool Custom RDP Configuration

Host Pool Custom RDP Configuration

Nerdio Manager allows you to customize a host pool's RDP settings.

See this Microsoft article for more information about RDP properties.

Note: You may create RDP settings profiles and apply them to host pools. See Configure RDP Settings Profiles for details.

To configure host pool's RDP settings:

  1. Locate the host pool you wish to work with.

  2. From the action menu, select PropertiesCustom RDP.

  3. Enter the following information:

    • Configuration: From the drop-down list, select the configuration to use.

      Note: If you select a RDP settings profile, you may not change any settings. Only the Custom option allow you to change settings.

    • Edit mode: For a Custom configuration, from the drop-down list, select the edit mode.

      • Common settings: You may select or unselect from a short list of the most commonly used settings.

      • Advanced: You may edit the full list of settings.

        • Select Not configured, or the existing value, to change the setting's value.

        • Select the tool tips to see more information about the setting and its values.

        • Select Clear to set the specific setting to Not configured.

        • Select Clear all to set all the RDP settings to Not configured.

        • Select Reset to Nerdio defaults to set all the RDP settings to Nerdio defaults.

          Nerdio Default Settings:

          devicestoredirect = *;

          redirectcomports = 1;

          audiomode = 0;

          audiocapturemode = 0;

          authenticationlevel = 3;

          autoreconnectionenabled = 1;

          bandwidthautodetect = 1;

          compression = 1;

          desktopsizeid = 0;

          disableconnectionsharing = 0;

          drivestoredirect = *;

          enablecredsspsupport = 1;

          encoderedirectedvideocapture = 1;

          gatewaycredentialssource = 0;

          gatewayprofileusagemethod = 0;

          keyboardhook = 2;

          networkautodetect = 1;

          promptcredentialonce = 1;

          remoteapplicationmode = 1;

          redirectclipboard = 1;

          redirectedvideocaptureencodingquality = 0;

          redirectprinters = 1;

          redirectsmartcards = 1;

          screenmodeid = 2;

          singlemoninwindowedmode = 0;

          smartsizing = 0;

          targetisaadjoined = 0;

          usbdevicestoredirect = *;

          usemultimon = 1;

          videoplaybackmode = 1;

          enablerdsaadauth = 0;

  4. Once you have entered all the desired information, select Save or Save & close.

Was this article helpful?

0 out of 0 found this helpful
Have more questions? Submit a request

Comments (0 comments)

Article is closed for comments.