Host Pool Sepago Azure Monitor Configuration

Host Pool Sepago Azure Monitor Configuration

Nerdio Manager allows you to enable Sepago Azure monitoring for hosts, users, and applications in a host pool.

Note: Nerdio recommends that the same log analytic workspace is used for all host pools. However, if you have a need to separate data based upon host pool, you may configure this at the host pool level from the host pool properties menu.

To configure host pool Sepago Azure monitor settings:

  1. Locate the host pool you wish to work with.

  2. From the action menu, select PropertiesSepago.

  3. Enter the following information:.

    • Enable Sepago Azure Monitor: Toggle on this option to enable this feature.

    • Workspace ID: Type the workspace ID.

      Note: The Workspace ID and Key can be found Log Analytics workspace > Settings > Agents Management > Windows Servers and enter the Workspace ID.

    • Key: Type the primary key.

    • Apply to existing hosts: Select this option to apply the change to existing hosts.

      • Process Host in Groups Of: Type the number of concurrent operations when applying the change.
      • Number of failures before aborting: Type the number of failed tasks before the process stops.

      • Messaging: Toggle on this option to send a message to all users on a session host before performing the operation.

        Note: Session hosts are placed into drain mode (deactivated) before the message is sent.

        • Delay: From the drop-down list, select the number of minutes to wait after sending the message before starting the process.
        • Message: Type the message you want to send to the users.

      • Schedule: Toggle on the Schedule to apply the changes at a selected time.
        • Start Date: Type the date to start.
        • Time Zone: From the drop-down list, select the time zone for the Start time.

        • Start Time: From the drop-down lists, select the time to start.

        • Repeat: From the drop-down list, select the recurring schedule, if desired.

          Note: The drop-down has the option After Patch Tuesday. This allows you to create a recurring schedule based on Patch Tuesday.

          • Days After: If you selected After Patch Tuesday, type the number of days after Patch Tuesday to run the scheduled task.

  4. Once you have entered all the desired information, select Save or Save & close.

Was this article helpful?

0 out of 0 found this helpful
Have more questions? Submit a request

Comments (0 comments)

Article is closed for comments.