Marek Sokół
Comments
Toby Skerritt the next level would be to apply fslogix profile at scaly (by this wizard from previous msg), and to keep individual share path for each host pool. So missing option named “keep curre...
Hi Toby Skerritt - thank you for implementing that in v7.Also like the when use override, nerdio remembers previous individual setting for share (so not need to set it from scratch).We are using ov...
Hi Toby Skerritt Thank for implementing that in v7.Unfortunately we face issue wit app installation took over 90 minutes and failing. To overcome this we introduced restarts after app installation ...
Fully agree with Neil, I already shared similar feedback.
Alternatively it would be just enough to be able to use “no change” settings and save/run. Unfortunatelly if “no change” is set, it is not possible to save/run task as save/run buttons are made ina...
Quite old topic but it is still valid. It is quite often then on average host pool from autoscale point of view is fine, but single session host can struggle with load much over the limits. If numb...
Hello Toby,
What is the status if this request?
Today when I logged in I found 1/3 session host in host pool with issue during application installation. But session host was normally power on by sc...
Hi Dave,
>Adjust the scale-in aggressiveness to medium, which will still remove unused hosts from the pool, but will not kick off a user who has an active session, no matter how much resource they ...
Tested on 6.7, I am now able to configure backup on hostpool with enabled hibernation.
Thank you.
Thank you, waiting for 6.7 GA, as 6.6 hass issue with supporting zip in Shall Aps
- Total activity 154
- Last activity
- Member since
- Following 0 users
- Followed by 1 user
- Votes 43
- Subscriptions 51